10-Key Calculator

A 10-key adding machine in your browser, built for bookkeepers and cashiers: type numbers, add and subtract them on a paper tape, check a subtotal without clearing, total a batch into the grand total, and keep adding. Works with the mouse or the keyboard.

0.00
Running total: 0.00Grand total: 0.00
Tape is empty. Enter a number and press + or −.

Keyboard: 0–9 and . to type · + − * / % for operations · Enter = Total · S = Subtotal · G = Grand Total · C = clear entry · Esc = Clear All · Backspace = delete last digit.

How it works: + adds the entry to the running total and − subtracts it. × multiplies the running total by the entry, ÷ divides it, and % adds that percent of the running total. Subtotal shows the running total without clearing anything. Total prints the total, adds it to the grand total, and starts a fresh batch. Grand Total recalls everything totaled so far. Amounts are kept in whole cents, so 0.10 + 0.20 comes out as exactly 0.30.

Frequently Asked Questions

What is the difference between Subtotal and Total?

Subtotal shows the running total of the batch you are working on, and nothing is cleared — you can keep adding entries afterwards. Total ends the batch: it prints the total, adds it to the grand total, and resets the running total to zero so the next batch starts clean.

What is the grand total (GT) for?

It adds up every Total you have taken. A cashier closing a drawer might total each stack of receipts separately and then press GT to see the day's combined figure; a bookkeeper might total each column of a ledger and then check the grand total against the control figure.

How does the % key work?

It adds that percent of the running total. If the running total is 200 and you enter 10 and press %, 20 is added and the total becomes 220. It is the adding-machine way of applying tax or a markup to a batch.

How does × work on an adding machine?

It multiplies the running total by the number you enter. If the running total is 100 and you enter 2 and press ×, the total becomes 200. ÷ works the same way in reverse.

Why do the amounts always show two decimals?

Because this is a money adding machine: every entry is stored in whole cents, so the tape never shows the floating-point dust you get from ordinary calculators (like 0.30000000000000004). Enter 10.50 as 10.50, not 1050.

Can I use this for a column of receipts?

Yes — that is what it is for. Type each receipt amount, press + after each one, and the tape shows every entry in order. Press Total when the column is done, then start the next column; GT gives you the combined figure at the end.