Rebar Calculator for Concrete Slab
How much rebar do you need for a slab? Enter the slab size, the grid spacing, and the bar size, and get the bar count, total length, and total weight — with a lap and waste allowance so you don't come up short.
Frequently Asked Questions
How do you count the bars in a slab grid?
Bars run in both directions. The bars parallel to the length are spaced across the width: count = (width ÷ spacing) + 1, including one bar at each edge. The bars parallel to the width are counted the same way across the length. Total length is the sum of both directions, and weight is total length times the bar's unit weight.
What spacing is typical for a residential slab?
#4 bars at 12–18 inches on center is common for driveways, patios, and slab-on-grade floors; #3 at 18–24 inches is used for lighter flatwork. The drawings govern — if a permit or engineer is involved, use the specified size and spacing, not this calculator's defaults.
What does each bar size weigh?
ASTM A615 nominal unit weights: #3 = 0.376 lb/ft, #4 = 0.668 lb/ft, #5 = 1.043 lb/ft, #6 = 1.502 lb/ft, #7 = 2.044 lb/ft, #8 = 2.670 lb/ft. A 20 ft stick of #4 weighs about 13.4 lb; a ton of #4 is about 2,994 ft, or roughly 150 sticks.
Why add a lap and waste allowance?
Bars come in 20 ft or 40 ft sticks, so long runs need lap splices (overlaps of 30–40 bar diameters), and cutting produces offcuts. 10% covers most rectangular slabs; use 15% for irregular shapes or many splices.
Rebar or welded wire mesh?
Mesh is cheaper and faster for light flatwork, but it is often stepped on during the pour and ends up at the bottom of the slab where it does little. Rebar on chairs stays at the right depth and is the safer choice for driveways and structural slabs. Either way, reinforcement belongs in the lower third of the slab, on chairs — not laid on the ground.