Log Weight Calculator

How heavy is a log? Measure the diameter, enter the length, pick the species, and get the green weight — per log and for the whole load. Densities are green (freshly cut) weights, the numbers that matter for hauling and handling. For board-foot yield instead, see the board foot calculator.

Estimate only. Real logs taper, so measure the diameter at the middle of the log, not the butt end — the cylinder formula below assumes a straight log. Moisture content varies by season and tree, so two logs of the same species and size can differ by 10% or more. Densities are green weights compiled from USDA Forest Products Laboratory-derived species data.

Frequently Asked Questions

How is log weight calculated?

Weight = volume × density. The log is treated as a cylinder: volume = π × (diameter ÷ 2)² × length, with diameter converted to feet. Example: a 20-inch diameter, 16-foot red oak log has volume π × (10 ÷ 12)² × 16 ≈ 34.91 ft³, and at 63 lb/ft³ green weighs about 2,199 lb — just over 1 US ton.

Green weight or dry weight — which do I use?

Green weight for anything freshly cut, hauled or handled. A freshly felled log can carry 40–100% of its dry weight in water, so dry lumber densities badly understate a green log: red oak is 63 lb/ft³ green but only about 44 lb/ft³ air-dried. Use dry densities only for seasoned lumber, never for a log off the stump.

Why mid-log diameter?

Logs taper from butt to top. The butt-end diameter overstates the average, the small-end diameter understates it. Mid-log diameter is the standard single-measurement compromise for weight estimates; for board-foot scaling, the industry instead uses the small-end diameter — see the board foot calculator.

Does bark count?

The densities here are wood densities, so measure diameter inside the bark for the closest result. Measuring over the bark reads slightly high — usually a few percent, more on thick-barked species.

How accurate is this?

Good enough for hauling, trailer capacity and handling plans; not a scale ticket. Moisture content is the biggest variable — a log cut in spring sap season weighs more than the same log cut in winter. Round up when checking a load limit.