Gutter Slope Calculator
A gutter is not hung level — it needs a slight slope so rainwater runs to the downspout instead of standing in the channel. The standard minimum is 1/4 inch of drop for every 10 feet of run. Enter your run length to get the required total drop, or work backwards from a drop to find the longest run it allows.
1/4 inch per 10 feet is the published minimum (Amerimax, SMACNA). Many installers use 1/16 inch per foot as the everyday target, and 1/2 inch per 10 feet where rainfall is heavy. Steeper than about 1/4 inch per foot starts to look visibly crooked against the fascia.
Minimum slope: Amerimax metal gutter system planning chart and installation sheet — slope at least 1/4 inch for every 10 feet toward the downspout (a 40-foot run draining to one end drops 1 inch); SMACNA Architectural Sheet Metal Manual — minimum 1/4 inch of fall per 10 feet of horizontal run. Typical 1/16 inch per foot target and 1/2 inch per 10 feet heavy-rain rate, and the 40-foot split-pitch rule, per published gutter sizing guides. Last verified November 2026.
Frequently Asked Questions
How much slope should a gutter have?
The published minimum is 1/4 inch of drop per 10 feet of run (0.025 inches per foot) toward the downspout. A 40-foot run draining to one end drops 1 inch from the high end to the outlet. Many installers use 1/16 inch per foot (0.0625 in/ft) as the everyday target, and 1/2 inch per 10 feet in heavy-rain areas.
What happens if the slope is too flat?
Water stands in the channel instead of draining. Standing water breeds mosquitoes, adds weight that pulls hangers loose, and in winter can freeze, expand and split seams. If you see water sitting in a gutter days after rain, the pitch is too flat (or a section has sagged) and needs re-hanging.
Can a gutter slope too much?
Yes. Past about 1/4 inch per foot the gutter looks visibly crooked next to the fascia, and during intense downpours water can overshoot the outlet at the low end. The working band is roughly 1/4 inch per 10 feet up to about 1/16 inch per foot — enough to drain, not enough to notice from the ground.
How do I slope a run longer than 40 feet?
Do not slope it end to end. Put the high point in the middle and pitch down in both directions to a downspout at each end (a split pitch or center drop). A single 60-foot slope at the minimum rate would need 1.5 inches of drop, which reads as a crooked line; two 30-foot slopes need only 3/4 inch each.
How do I check the slope on an existing gutter?
Measure the drop directly: hold a level at the high end, mark the fascia, then measure down to the gutter at the downspout end and divide by the run length. Or pour a bucket of water in at the high end and watch — it should flow steadily to the outlet without pooling. A string line pulled taut along the gutter also shows sagging spots.
Does gutter size change the slope needed?
No — slope and size are separate. Slope controls how fast water moves to the outlet; gutter size (5-inch vs 6-inch) and downspout count control how much water the system can carry. A correctly sloped 5-inch gutter still overflows in a storm if the roof area feeding it needs a 6-inch gutter or a second downspout.