Foundation Repair Cost Calculator

Foundation repair is priced by method, not by the square foot of your house — piers are priced per pier, cracks per foot, anchors per anchor. Enter the quantities from your inspection report and the rates from your quotes (or use the published defaults below) and this page totals each method and the whole job, with a low–high range.

Repair methodYour rate ($)QuantityLine total
Helical piers per pier · published $1,000 – $3,000
Concrete / steel push piers per pier · published $1,000 – $3,000
Crack repair per linear ft · published $500 – $3,000
Waterproofing (interior drain) per linear ft · published $40 – $100
Slab jacking / mudjacking per sq ft · published $3 – $8
Basement wall anchors per anchor · published $400 – $700
Rough estimate, not a contractor quote — and not a diagnosis. Foundation problems are structural: get a structural engineer's report and two or three quotes from foundation contractors for the same scope before spending. Pier depth, soil, access, engineering, permits, and restoration can move the final price far from any national average. If a wall is bowing, a crack is widening, or a floor is sinking, get it inspected promptly rather than budgeting from this page alone.

Sources: Angi, "How Much Does Foundation Repair Cost?" (August 2026) — national average $5,174, most jobs $2,225–$8,133, piers $1,000–$3,000 each; Angi, "Bowing Basement Wall Repair Cost" (October 1, 2026) — wall anchors $400–$700 each; Cost to Renovate, "Foundation Repair Cost in 2026" — crack repair $500–$3,000 per linear ft (average $1,500), slab jacking/mudjacking $3–$8 per sq ft; interior perimeter drain $40–$100+ per linear ft (industry-standard range cited in contractor cost guides; a typical full waterproofing job runs about $2,500–$8,000, Angi average $5,241, July 2026). Note: many guides quote crack injection per crack instead ($250–$800, Angi) — if your quote is per crack, enter that rate and set the quantity to the number of cracks. Ranges last verified November 2026.

Formula: each line total = rate × quantity; job total = sum of line totals. The low–high range sums each method's published low/high rate × its quantity.

Frequently Asked Questions

How much does foundation repair cost on average?

Angi's August 2026 data puts the national average at $5,174, with most jobs between $2,225 and $8,133. But the average blends tiny crack repairs with $30,000 piering jobs, so it is a poor guide to your job — price the specific methods your foundation needs, which is what this calculator does.

How many piers does a settling house usually need?

Most piering jobs need 6–15 piers, at $1,000–$3,000 per pier installed (Angi). That is why a full underpinning job typically runs $10,000–$30,000 or more: the per-pier price looks manageable, but the count drives the total. Only a structural engineer can say how many piers your house needs and how deep they must go.

Why is crack repair priced per linear foot here when some guides price it per crack?

Both conventions exist. Cost to Renovate publishes $500–$3,000 per linear ft (average $1,500), while Angi quotes crack injection at $250–$800 per crack. If your contractor quoted per crack, enter that rate in the crack row and set the quantity to the number of cracks — the math is the same, only the unit changes.

What is the difference between slab jacking and piers?

Slab jacking (mudjacking) pumps grout under a sunken concrete slab to lift it — about $3–$8 per sq ft — and suits slabs, driveways, and garage floors. Piers go deep into stable soil to support the house itself and are the fix for a settling foundation. They solve different problems and are not interchangeable.

Does homeowners insurance cover foundation repair?

Usually not. Standard policies exclude damage from settling, soil movement, and wear — the causes behind most foundation problems. Coverage sometimes applies when the damage comes from a covered event such as a burst pipe, but check your policy and get the engineer's report first.