Feeds and Speeds Calculator

How fast should the spindle turn, and how fast should the cutter move? Enter the tool diameter and cutting speed to get RPM, then add flutes and chip load to get the feed rate — the standard mill formulas, in one place.

Starting values, not gospel. The SFM presets are typical starting values for carbide end mills; high-speed steel (HSS) tools run at roughly half these speeds. Chip load depends on tool diameter, material, and rigidity — start low on a light machine and work up. Always check your tool manufacturer's recommended speeds and feeds, and never exceed your machine's maximum RPM.

Frequently Asked Questions

What is SFM (cutting speed)?

Surface feet per minute — how fast the cutting edge moves through the material. It depends on the material being cut and the tool material, not on the tool diameter. A bigger tool at the same SFM simply turns slower, because the edge has further to travel per revolution.

How do you calculate RPM from SFM?

RPM = SFM × 3.82 ÷ tool diameter in inches. The 3.82 is 12 ÷ π. For example, 600 SFM with a 1/2-inch tool gives 600 × 3.82 ÷ 0.5 = 4,584 RPM. The reverse is SFM = RPM × diameter ÷ 3.82.

How do you calculate feed rate?

Feed rate (inches per minute) = RPM × number of flutes × chip load per tooth. With 4,584 RPM, 2 flutes, and 0.003 inches per tooth, the feed is 4,584 × 2 × 0.003 = 27.5 inches per minute.

What chip load should I use?

As a starting point for carbide end mills in aluminum: about 0.001–0.002 in/tooth for a 1/8-inch tool, 0.002–0.004 for 1/4-inch, 0.003–0.006 for 1/2-inch, and 0.006–0.012 for a 1-inch tool. Steels run at roughly half those values. Too small a chip load rubs and generates heat; too large breaks the tool.

HSS or carbide speeds?

Carbide tolerates much higher cutting speeds than high-speed steel — roughly double the SFM for the same material. The presets on this page are carbide values; for HSS tools, halve the SFM before calculating RPM.

Why does feed rate matter?

Feed sets the chip thickness. Too slow and the cutter rubs instead of cutting, work-hardening the material and dulling the tool. Too fast and the tool deflects or breaks. The right feed is the one that produces a clean chip at the target chip load.