Cut List Optimizer

Fewest boards, least waste. Enter your stock board length, your saw's kerf (blade width), and the cuts you need — length and quantity — and get the board count, the cut layout for each board, the waste percentage, and the total cost if you enter a price per board.

Required cuts

All lengths in inches. Kerf is the width of material the blade removes on each cut — it is charged between cuts on the same board, not after the last cut. Results update as you type; the optimizer packs longest cuts first (first-fit decreasing), which is usually within one board of optimal for small lists but is not guaranteed to be the true optimum.

Frequently Asked Questions

What is kerf?

Kerf is the slot the saw blade cuts away — for a standard 10-inch table saw blade it is usually 1/8 inch (0.125 in); a thin-kerf blade is about 3/32 inch (0.094 in). Ignoring kerf makes layouts look better than they really are: two 48-inch cuts do not fit a 96-inch board once the blade takes its 1/8 inch between them.

How does the optimizer pack cuts?

First-fit decreasing: cuts are sorted longest-first, and each cut goes into the first board it fits on, counting kerf between cuts. Longest-first matters — packing short cuts first strands long offcuts that fit nothing. Example: 96-inch stock, 0.125-inch kerf, two 48-inch cuts and four 24-inch cuts need 3 boards: board 1 gets 48 + 24, board 2 gets 48 + 24, board 3 gets 24 + 24, with 33.2% waste.

Is the result the true optimum?

Not guaranteed. First-fit decreasing is a fast heuristic, not an exhaustive search. For typical short cut lists it lands on or within one board of optimal. If the waste percentage looks high, try a different stock length — buying 12-foot boards instead of 8-foot boards often cuts waste more than any packing trick.

What if a cut is longer than the stock board?

It is listed as unplaceable and left out of the board count. Buy longer stock for that cut, or join shorter pieces — no packing arrangement can fit a 100-inch cut on a 96-inch board.

Does this work for sheet goods like plywood?

No — this is a 1D (length-only) optimizer for boards, trim, and bars. Sheet goods need 2D nesting (length × width), which is a different problem.