Board Foot Calculator

How many board feet are in a log? Measure the small-end diameter inside the bark and the length, and get both the Doyle scale and the Scribner Decimal C scale — then tally a whole load of logs and price it. A lumber board-foot calculator is at the bottom of the page.

One log

Log tally

Add each log you measured. Totals update as you add or remove rows.

Doyle underscales small logs — it deducts a fixed 4 inches, so a small log loses a bigger share of its diameter. That is why Doyle favors the buyer on small timber. For a sale, check which rule your buyer scales on; the Scribner figure here uses the standard Decimal C approximation formula, rounded to the nearest 10, while official Scribner is a published table — the table governs if the two disagree.

Lumber board feet

Frequently Asked Questions

What is a board foot?

One board foot = 144 cubic inches of wood — a piece 12 inches long, 12 inches wide and 1 inch thick. For lumber: board feet = (thickness in inches × width in inches × length in feet) ÷ 12. A 2×6 board 8 ft long is 2 × 6 × 8 ÷ 12 = 8 board feet.

How does the Doyle scale work?

Doyle: board feet = (D − 4)² × length ÷ 16, where D is the small-end diameter inside the bark in inches and length is in feet. The 4 inches is a fixed deduction for saw kerf and waste. Example: a 16-inch diameter, 16-foot log scales (16 − 4)² × 16 ÷ 16 = 144 board feet.

How does the Scribner scale work?

Scribner is a diagram-based rule published as a table, not a formula. The widely used Decimal C approximation is board feet = (0.79 × D² − 2 × D − 4) × length ÷ 16, with the result rounded to the nearest 10. Example: a 12-inch, 16-foot log gives (0.79 × 144 − 24 − 4) = 85.76, or 90 in Decimal C. If your buyer scales on an official Scribner table, that table governs.

Why do Doyle and Scribner give different numbers?

They assume different amounts of waste and taper. Doyle's fixed 4-inch deduction hits small logs hardest, so Doyle reads low on small timber and roughly matches Scribner on large logs. The two rules exist because different regions and buyers adopted different standards — always confirm which rule your buyer uses before you agree on a price.

How do I measure a log for scaling?

Measure the diameter at the small end, inside the bark, in inches — not the circumference, and not the big end. Measure the merchantable length in feet. Crooked, hollow or heavily knotted logs scale lower than the formula says; deduct for visible defect before you price the load.

What does MBF mean?

MBF = 1,000 board feet. Log prices are usually quoted per MBF: a load scaling 2,400 board feet at $450/MBF is worth 2.4 × $450 = $1,080.